We offer water well boring services in Lahore and Karachi. In this field we can deliver water capacity up to its maximum for industrial , agricultural and domestic use depending on the required consumption and usage according to consumer . It starts with boring a hole in the ground from 200 feet up to 1500 feet and vice versa .
Before you start digging a hole for water it is highly suitable if you get your pre bore assessments done so that you don't waste time and money that's where we come in. We will give you feasibility study and water table diagnostics depending on your area and demand for water supply.
If you already have drilled a bore that needs maintenance and management we can also offer you services for that as well. From supply maintenance to equipment look after we are here to help water on an equitable basis to satisfy all uses and demands. As with other resource management.
Earthing and insulating is a very important and required need when working with high voltage equipment (generators,mills) and is generally required to be earthed and insulated properly for the sake of safety of staff and workers in family and offices and requires a bore hole which needs to be filled with electrolyte with copper plates dipped in it which is attached to a high grade copper wire coming from the attached equipment and machinery
As water shortages have been increasing over the years due to hot weather normal and domestic water supply coming from Taps has not been able to fulfill house hold demands and when the water does come it has been polluted . In order to get sufficient and reliable water supply we offer our customers domestic boring services for house which is normally done to 200 or 300 feet and gives you clean pure and unlimited supply of cold water with the push of a button
We also offer plumbing solutions for pipe fittings from new house construction to maintenance of old pipes our plumbers are available to your every demand An elbow is installed between two lengths of pipe (or tubing) to allow a change of direction, usually a 90° or 45° angle; 22.5° elbows are also available. The ends may be machined for butt welding, threaded (usually female), or socketed. When the ends differ in size, it is known as a reducing (or reducer) elbow.
There is a moment in the life of any aspiring astronomer that it is time to buy that first telescope. It’s exciting to think about setting up your own viewing station whether that is on the deck